Material Safety Data Sheet

May be used to Comply with OSHA’s

Hazard Communication Standard,

 29 CFR 1910.1200.  Standard must be

Consulted for specific requirements

HMIS

HEALTH                                                   0        REACTIVITY                               0

FLAMMABILITY                                     0          PERSONAL PROTECTION     A

Identity (As Used On Label and List)

B4200  SG Grease Tube

Note:  Blank spaces are not permitted.  If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for:

OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number:

1-800-424-9300

Address (Number, Street, City, State, and Zip Code)

101 Grobric Ct. Unit #1

Telephone Number for Information:

1-800-571-7347

Fairfield, CA 94534

Date Prepared

01-22-2009

 

 

Signature of Prepare (Optional)

REGULATORY DEPT.

Section II - Ingredients / Identity Information

Components

(Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits

Recommended

%(Wt.)

Silcone Grease

63148-62-9

N/E

—

 

 

Polytetra Fluroethane

9002-84-0

15mg/m3

15mg/m3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This product is not known to contain any compounds listed and in quantities requiring reporting under SARA Title III

Section 313

 

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

 

Section III - Physical Chemical Characteristics

Boiling Point

 

>550°F

Specific Gravity (H2O = 1)

Concentrate

1.1

Vapor Pressure (mm/hg)

 

N/D

Melting Point

 

None

Vapor Density (Air=1)

 

—

Evaporation Rate (Butyl Acetate = 1)

 

0

Solubility in Water

 

None

Reactivity in Water

 

None

Appearance and Odor— Odorless, translucent white grease-like paste.

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

—

>550 F (C.O.C)

N/d

N/A

Extinguishing Media – Foam, CO2, Dry Chemical

Special Fire Fighting Procedures – This compound will not burn unless it is pre-heated. Water fog may be used to cool the containers but do not spray directly into large containers of burning liquids as frothing may occur. Wear a “N.I.O.S.H” approved organic vapor respirator.

Unusual Fire and Explosion Hazards – Dense smoke and noxious or toxic fumes may be generated in a fire. Fire fighters should wear a self contained breathing apparatus.

 

Page 2 of 2 for    B4200 SG Grease Tube

Section V – Reactivity Data

Stability

 

Unstable

Conditions to Avoid –

N/A

Hazardous

Polymerization

May Occur

Stable

X

Will Not Occur

X

Incompatibility (Materials to Avoid) –  N/A

Hazardous Decomposition or Byproducts – The thermal decomposition products are highly dependent upon the combustion conditions. Noxious or toxic fumes may be generated, some of which may be toxic or irritating .

Section VI – Health Hazard Data

Route(s) of Entry:

 

Eyes? 

No

Inhalation?

No

Skin?

Yes

Ingestion?

No

Health Hazards (Acute and Chronic) –

This product is relatively non –irritating and low toxicity.

 

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

No

No

No

Signs and Symptoms of Exposure:

Eyes— May cause slight irritation.

Inhalation— Not likely under normal conditions of use.

Ingestion— Not likely under normal conditions of use.

Medical Conditions Generally Aggravated –None known.

Emergency and First Aid Procedures. 

Eyes—Flush eye with water for 15 minutes. Lifting the eyelids. If irritation persists consult a physician.

Skin— Wash with soap and water, using a nail brush. Pay particular attention to finger nails and open wounds,

Inhalation—If using in high temperature applications where thermal decomposition is likely, use a local exhaust to remove fumes. If dizziness or irritation occurs, seek fresh air.

Ingestion— If ingested this products is not expected to cause an acute reaction. Do not induce vomiting, because it may be aspirated into the lungs. Use a gastric lavage, and call a poison control center or a physician.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled.

The viscous nature of this product makes spill unlikely. Scoop up the material and return to its original container, or use an oil absorbent material and dispose of properly.

 

Waste Disposal Method – Dispose of in accordance with state and local regulations. Do not discharge into sewer or waterways.

Precautions to be Taken in Handling and Storing –

Store in closed containers away from intense heat or open flames. Do not transfer to unmarked containers.

 

Other Precautions – KEEP AWAY AND OUT OF REACH OF CHILDREN.

Section VIII – Control Measures

Respiratory Protection (Specify Type) –

Normally not required. If this product is being used in high temperature applications where the product “smokes”, use a local exhaust or ventilate the area to maintain the air quality, or use a “N.I.O.S.H.”  approved organic vapor respirator

Ventilation

Local Exhaust

Adequate

Special

 

Mechanical (General)

 

Other

 

Protective Gloves –

Not normally required.

Eye Protection –

Safety glasses are recommended.

Other protective Clothing or Equipment –N/A

Work/Hygienic Practices – Use good standard practices when using this material. Do not eat or smoke while using. Observe good hygiene.  Wash hands thoroughly after eating, drinking, and using restrooms, etc. Do not smoke while using.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.