Material Safety Data Sheet

May be used to Comply with OSHA’s

Hazard Communication Standard,

 29 CFR 1910.1200.  Standard must be

Consulted for specific requirements

HMIS

HEALTH                                                   1        REACTIVITY                                0

FLAMMABILITY                                      2      PERSONAL PROTECTION          B

Identity (As Used On Label and List)

G3028P  Numb Bug

Note:  Blank spaces are not permitted.  If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Distributed by:

OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number:

1-800-424-9300

Address (Number, Street, City, State, and Zip Code)

4950 Fulton Dr Ste B

Telephone Number for Information:

1-800-571-7347

Fairfield, CA 94534

Date Prepared

03-08-1996

 

 

Signature of Prepare (Optional)

REGULATORY DEPT.

Section II - Ingredients / Identity Information

Components

(Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits

Recommended.

%(Wt.)

d-TRANS Allethrin

28057-48-9

N/E

N/E

 

 

Piperonyl Butoxide Technical

51-03-5

NE

N/E

 

 

N-octyl bicycloheptene dicarboximide

113-48-4

N/E

N/E

 

 

Isoparaffinic Petroleum Solvent

64742-47-8

100 ppm

100 ppm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This product is not known to contain any compounds listed and in quantities requiring reporting under SARA Title III

Section 313

 

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

 

Section III - Physical Chemical Characteristics

Boiling Point

 

N/A

Specific Gravity (H2O = 1)

Concentrate

0.82

Vapor Pressure (mm/hg) @ 25ºC

 

 <2

Lbs/Gal

 

6.8

Vapor Density (Air=1)

 

>5

Evaporation Rate (Butyl Acetate = 1)

 

<0.1

Solubility in Water

 

Insoluble

pH

 

N/A

Appearance and Odor— Thin, light yellow, clear liquid with very mild odor.

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

150ºF (TCCP)

N/E

N/E

N/E

Extinguishing Media –Foam, carbon dioxide, dry chemical and water fog.

Fire Fighting Procedures –Use self-contained breathing apparatus pressure demand, MSHA/NIOSH approved (or equivalent) and full protective gear.  Cool fire-exposed areas and equipment.  Do not use direct stream of water.  Material may float and re-ignite.

Unusual Fire and Explosion Hazards – N/A

 


Page 2 of 2 for     G3028P Numb Bug

Section V – Reactivity Data

Stability

 

Unstable

Conditions to Avoid

N/A

Hazardous

Polymerization

May Occur

Stable

x

Will Not Occur

x

Incompatibility (Materials to Avoid) – Strong oxidizing agents

Hazardous Decomposition or Byproducts –None known.

Section VI – Health Hazard Data

Route(s) of Entry:

 

Eyes? 

Yes

Inhalation?

Yes

Skin?

Yes

Ingestion?

Yes

Health Hazards (Acute and Chronic)

See Below

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

No

No

No

Signs and Symptoms of Exposure:

Eyes—Non irritating

Skin—Harmful if absorbed through skin.

Inhalation—N/A

Ingestion—Harmful if swallowed.

Medical Conditions Generally Aggravated –N/A

Emergency and First Aid Procedures. 

Eyes— Flush with water for 10-15 minutes.  Contact a physician if irritation persists.

Skin—Remove contaminated clothing.  Wash skin with soap and water.  Contact a physician if irritation persists.

Inhalation— Remove affected person to fresh air.  Apply artificial respiration if indicated.

Ingestion—.Contact a physician or Poison Control Center immediately.  Do not induce vomiting unless directed to do so by a physician.  This product contains petroleum distillate.  Vomiting may cause aspiration pneumonia.  Do not give anything by mouth to an unconscious person.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled.

Soak up with an absorbent material such as sand sawdust, earth, etc. Dispose of with chemical waste.

Waste Disposal Method –. Do not contaminate waterways by cleaning of equipment or by disposal of wastes.  Untreated effluent should not be discharged where it will drain into lakes, streams, or ponds.  Empty container may retain vapor or product residue.  Observe all labeled safeguards until container is cleaned, reconditioned or destroyed.

Precautions to be Taken in Handling and Storing –

Avoid breathing vapors or spray mist.  Avoid contact with skin and eyes.  Do not contaminate water, food, or feed by storage or disposal.  Do not apply directly to food.  Cover or remove food and food processing equipment before application.  Do not apply while food processing is underway.  After spraying in food processing plants, wash all equipment thoroughly with soap and hot water.  All food processing surfaces should be covered during treatment or washed before use.  Storage precautions:  Store upright at room temperatures.  Avoid exposure to extreme temperatures.  Containers smaller than one gallon:  Store in original container in a cool dry place inaccessible to children and pets. 

Section VIII – Control Measures

Respiratory Protection (Specify Type) –

Use in well ventilated areas.  Pesticide respirator jointly approved by MENSA or OSHA under provisions.

Ventilation

Local Exhaust

Adequate

Special

 

Mechanical (General)

Adequate

Other

 

Protective Gloves –

Rubber or impervious gloves.

Eye Protection –

Safety glasses or goggles.

Other protective Clothing or Equipment – N/A

Work/Hygienic Practices – Observe good hygiene.  Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.