MATERIAL Safety Data Sheet May be used to Comply with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. Standard must be Consulted for specific requirements

HMIS

HEALTH 1 REACTIVITY 3

FLAMMABILITY 3 PERSONAL PROTECTION G

Identity (As Used On Label and List) A1125W Mark It WHITE

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for: OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number: 1-800-424-9300

Address (Number, Street, City, State, and Zip Code) 101 Grobric Ct #1

Telephone Number for Information: 1-800-571-7347

Fairfield, CA 94534

Date Prepared 04-28-2004

Signature of Prepare (Optional) REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components (Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits Recommended.

%(Wt.)

Propane

74-98-6

1000 ppm

1000 ppm

10-20

Calcium Carbonate

1317-65-3

N/A

N/A

10-20

n-Butane

106-97-8

800 ppm

800 ppm

10-20

VM&P Naphtha

64742-89-8

100 ppm

100 ppm

01-10

Titanium Dioxide

13463-67-7

5mg/m^3

10mg/m^3

01-10

Toluene*

108-88-3

200 ppm

50 ppm

01-10

Xylene (mix)*

1330-20-7

100 ppm

100 ppm

01-10

n-Hexane*

110-54-3

500 ppm

50 ppm

01-10

Mineral Spirits

64742-47-8

100 ppm

100 ppm

01-10

Ethyl Benzene*

100-41-4

100 ppm

100 ppm

01-10

"*" If present, IARL, NTP and OSHA carcinogens and chemical subject to this reporting requirements of SARA Title III, Section

313 are identified in this section.

**WARNING This product contains a chemical known to the state of California to cause birth defects or other reproductive harm.

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

Section III - Physical Chemical Characteristics

Boiling Point

-47ºF

Specific Gravity (H2O = 1) @ 75ºF Concentrate

0.77—0.90

Vapor Pressure @ 68ºF

(6226 mm/hg) 8300.0 hPa

pH

N/A

Vapor Density (Air=1)

>1

VOC% by weight

49.9%

Solubility in Water

Miscible

Solids Content

31.4%

Water Content

18.4%

VOC Content

0.50 kg/l

Appearance and Odor— White coating with solvent odor.

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

Extremely Flammable Spray

-2ºF

N/A

N/A

Extinguishing Media – Dry media, CO2, water spray, sand.

Special Fire Fighting Procedures –Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.

Unusual Fire and Explosion Hazards – Exposure to temperature above 120ºF may cause bursting.

Page 2 of 2 for A1125W Mark It WHITE

Section V – Reactivity Data

Stability

Unstable

Conditions to Avoid – None

Hazardous Polymerization

May Occur

Stable

X

Will Not Occur

X

Incompatibility (Materials to Avoid) – Strong oxidizing agents.

Hazardous Decomposition or Byproducts – Carbon monoxide, carbon dioxide.

Section VI – Health Hazard Data

Route(s) of Entry:

Eyes? Yes

Inhalation? Yes

Skin? Yes

Ingestion? Yes

Health Hazards (Acute and Chronic) – See Below

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

No

N/A

N/A

N/A

Signs and Symptoms of Exposure: Eyes—Irritating effect. Skin—Frequent or prolonged contact may cause irritation. Inhalation—Inhalation of mist can cause irritation of nasal and respiratory passages. Abusive or excessive inhalation may cause irritation to the upper respiratory tract, dizziness, nausea and other central nervous system effects. Ingestion— Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause chemical pneumonitis.

Medical Conditions Generally Aggravated –None Known

Emergency and First Aid Procedures. Eyes—Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention immediately. Skin—Wash with soap and water. If irritation persists seek medical attention. Inhalation— Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration. Ingestion—Do not induce vomiting. Seek medical attention immediately.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled. Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks, heat sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in accordance with Federal state and local law.

Waste Disposal Method – Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult federal, state and local authorities for approved procedures.

Precautions to be Taken in Handling and Storing – Store in a cool, dry area away from heat or open flame. Do not store at temperatures above 120ºF.

Other Precautions –KEEP OUT OF REACH OF CHILDREN.

Section VIII – Control Measures

Respiratory Protection (Specify Type) – If ventilation is not adequate to reduce vapors below Threshold limit value (TLV) levels, use a NOSH/MSHA approved air-purifying respirator.

Ventilation

Local Exhaust

Adequate

Special

Mechanical (General)

Other

Protective Gloves – Chemical gloves if hand contact will be made.

Eye Protection – Chemical proof goggles

Other protective Clothing or Equipment – NA

Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.