Material Safety Data Sheet May be used to Comply with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. Standard must be consulted for specific requirements

HMIS

HEALTH 1 REACTIVITY

FLAMMABILITY 2 PERSONAL PROTECTION N/A

Identity (As Used On Label and List) G3059 QDS (Quick Dry Sealer)

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for: OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number: 1-800-424-9300

Address (Number, Street, City, State, and Zip Code) 101 Grobric Ct #1

Telephone Number for Information: 1-800-571-7347

Fairfield, CA 94534

Date Prepared 03-25-2011

Signature of Prepare (Optional) REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components (Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits Recommended

%(Opt.)

Aliphatic Petroleum Distillates

8052-41-3

100ppm

100ppm

N/A

(Mineral Spirits)

Solvent Naptha

64741-65-7

300 ppm

300 ppm

Solvent Naptha

64742-95-6

100 ppm

100 ppm

Section III – Physical Chemical Characteristics

Boiling Point Concentrate – Initial

300-350ºF

Specific Gravity (H2O = 1) Concentrate

0.82

Vapor Pressure

N/A

Melting Point

N/A

Vapor Density

>1

Evaporation Rate (Butyl Acetate = 1)

N/E

Solubility in Water

<5%

pH

Appearance and Odor— Clear, honey color liquid with characteristic odor.

VOC %

N/A

Section IV – Fire and Explosion Hazard Data

Flash Point

Flammable Limits

LEL

UEL

102ºF seta flash. Combustible

0.7

N/E

Extinguishing Media – Use foam, carbon dioxide or dry chemical fire fighting apparatus.

Special Fire Fighting Procedures –Self-contained breathing apparatus is recommended for fire fighters. Water spray may be used for cooling containers to prevent possible pressure build-up and possible auto ignition or explosion when exposed to extreme heat.

Unusual Fire and Explosion Hazards - Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Closed containers may explode when exposed to extreme heat.

Page 2 of 2 for G3059 QDS (Quick Dry Sealer)

Section V – Reactivity Data

Stability

Unstable

Conditions to Avoid – Isolate from heat.

Hazardous Polymerization

May Occur

Stable

X

Will Not Occur

X

Incompatibility (Materials to Avoid) - Avoid contact with strong oxidizing agents.

Hazardous Decomposition or Byproducts –Thermal decomposition may yield carbon dioxide and/or carbon monoxide.

Section VI – Health Hazard Data

Route(s) of Entry:

Eyes? N/A

Inhalation?

Skin?

Ingestion?

Health Hazards (Acute and Chronic) – Acute: Eye— Severe irritation, redness, tearing and blurred vision. Skin — Prolonged or repeated exposure can cause moderate irritation, defatting and dermatitis. Inhalation—Excessive inhalation of vapors can cause nasal and respiratory irritation, dizziness, weakness, fatigue, nausea and headache. High concentrations may result in narcosis. Ingestion— Can cause gastrointestinal irritation, nauseam vomiting and diarrhea. Aspiration of material into lungs can cause chemical pneumenitis which can be fatal. Chronic: None known

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

Signs and Symptoms of Exposure: See health hazards above.

Medical Conditions Generally Aggravated –None known.

Emergency and First Aid Procedures: Eyes-Flush with water for 15 minutes obtain medical attention. Skin- Remove contaminated clothing, wash affected area thoroughly with soap and water. Inhalation- Remove to fresh air, apply artificial respiration or administer oxygen if necessary. Call physician immediately. Ingestion-Keep patient warm, quiet & get immediate medical attention. Do Not induce vomiting.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled – Remove all sources of ignition. Ventilate the area, dike around spilled material, and cover spill with inert absorbent material and shovel with non-sparking tools into container. Remove containers to a safe area and seal.

Waste Disposal Method –Any method for the disposal of chemical waste subject to local regulations.

Precautions to be Taken in Handling and Storing – Protect against physical damage. Outside or detached storage preferred. Storage should be in standard flammable liquid storage tanks.

Other Precautions –All equipment should be grounded & bonded to reduce electricity hazard. Use non-sparking tools.

Section VIII – Control Measures

Respiratory Protection (Specify Type) – Use self-contained breathing apparatus where vapor concentration may be above TLV limits.

Ventilation

Local Exhaust

May be sufficient

Special

Not Established

Mechanical (General)

May be needed

Other

Not Established

Protective Gloves – Chemical resistant.

Eye Protection - Safety glasses with side shields.

Other protective Clothing or Equipment –Eye wash & safety shower, impervious clothing & boots.

Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after product use, eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.