Material Safety Data Sheet May be used to Comply with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. Standard must be Consulted for specific requirements

HMIS

HEALTH 1 REACTIVITY 0

FLAMMABILITY 4 PERSONAL PROTECTION B

Identity (As Used On Label and List) A1096 EZ Kleen Xtra

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for: OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number: 1-800-424-9300

Address (Number, Street, City, State, and Zip Code) 101 Grobric Ct #1

Telephone Number for Information: 1-800-571-7347

Fairfield, CA 94534

Date prepared 10-31-2010

Signature of Prepare (Optional) REGULATORY DEPT.

Section II - Hazarous Ingredients / Identity Information

Components (Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits Recommended.

%(Wt.)

Sodium Metasilicate

6834-92-0

15mg/m^3

10mg/m^3

<3.0

Diethylene Glycol Monoethyl Ether *

111-90-0

N/E

N/E

<12.0

Propellent Mixture

Propane

74-98-6

1000 ppm

N/A

N-Butane

106-97-8

600 ppm

N/A

*This product contains the toxic chemicals marked with an * subject to the reporting requirements of Section 313 of the emergency.

planning and community right-to know act of 1986 and of 40CFR372.

Section III - Physical Chemical Characteristics

Boiling Point

200ºF

Specific Gravity (H2O = 1) Concentrate

1.04

Vapor Pressure (mm/hg)

N/E

Melting Point

Vapor Density (Air=1)

N/E

Evaporation Rate (Butyl Acetate = 1)

N/E

Solubility in Water

Complete

pH

12.5

Appearance and Odor— Slightly cloudy, colorless spray with mild odor.

VOC % Content

17.5%

Section IV – Fire and Explosion Hazard Data

Flash Point

Flammable Limits

LEL

UEL

No flash by standard methods

N/A

N/A

Extinguishing Media – Dry chemical, CO2, or foam is recommended.

Special Fire Fighting Procedures –CAUTION. Contents under pressure. Cool exposed containers with water spray to prevent bursting. SCBA should be used whenever chemical fires are present.

Unusual Fire and Explosion Hazards – N/A

Page 2 of 2 for A1096 EZ Kleen Xtra

Section V – Reactivity Data

Stability

Unstable

Conditions to Avoid – High temperatures.

Hazardous Polymerization

May Occur

Stable

X

Will Not Occur

X

Incompatibility (Materials to Avoid) - Strong oxidizers, acids.

Hazardous Decomposition or Byproducts – CO2, CO.

Section VI – Health Hazard Data

Route(s) of Entry:

Eyes? —

Inhalation? Yes

Skin? Yes

Ingestion? —

Health Hazards (Acute and Chronic) – Eyes—Causes severe irritation, experienced as discomfort or pain, excess blinking and tears production, with redness and swelling of the conjunctiva. Skin— Brief contact may cause slight irritation. Prolonged contact may cause more severe irritation with pain, local redness and swelling. Inhalation—High vapor/aerosol concentrations (>1000 ppm) are irritating to the respiratory tract. Ingestion—May cause headache, dizziness, incoordination, nausea, vomiting, diarrhea and general weakness.

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

N/L

N/L

N/L

Signs and Symptoms of Exposure: Dermal exposure may cause local redness and swelling, pain and discomfort.

Medical Conditions Generally Aggravated –None Known

Emergency and First Aid Procedures. Eyes — Immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention immediately. Skin— Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Get medical attention immediately. Inhalation — Remove to fresh air if not breathing, give artificial respiration. If breathing is difficult, give oxygen. Ingestion— Seek medical attention immediately. Call a poison control center or doctor for treatment advice. Have person sip a glass of water if able to swallow. Never give anything by mouth to an unconscious person.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled. Stop all leaks. Isolate hazard area. Keep unnecessary and unprotected personnel from entering. Eliminate all ignition sources. Disperse vapors with water spray. Prevent runoff from entering drains, sewers, streams or other bodies of water. Absorb spill with inert material. Absorb unrecoverable product. Transfer contaminated absorbent, soil and other materials to containers for disposal.

Waste Disposal Method – Waste must be disposed of in accordance with federal, state and local environmental control regulations.

Precautions to be Taken in Handling and Storing – Do not use or store near heat, sparks or open flame. Exposure to temperatures above 120ºF may cause bursting. Do not puncture or incinerate container. Store in a cool, dry place. Do not get in eyes, on skin or clothing. Intentional misuse by deliberately concentrating and inhaling may be harmful or fatal. Keep Out of children.

Other Precautions—N/A

Section VIII – Control Measures

Respiratory Protection (Specify Type) – When respiratory protection is required, use an organic vapor & particulate cartridge. A respiratory program that meets OSHA’s 29 CFR 1910.34 & ANSI Z88.2 requirements must be followed.

Ventilation

Good general ventilation required.

Protective Gloves –To prevent repeated or prolonged contact, wear impervious gloves (made from rubber, nitrile or neoprene).

Eye Protection – Wear goggles or safety glasses

Other protective Clothing or Equipment – N/A

Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.