Material Safety Data Sheet

May be used to Comply with OSHA’s

Hazard Communication Standard,

 29 CFR 1910.1200.  Standard must be

Consulted for specific requirements

HMIS

HEALTH                                                   0        REACTIVITY                               0

FLAMMABILITY                                     0      PERSONAL PROTECTION          B

Identity (As Used On Label and List)

A1017 Always Shine WB

Note:  Blank spaces are not permitted.  If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for:

OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number:

1-800-424-9300

Address (Number, Street, City, State, and Zip Code)

101 Grobric Ct #1

Telephone Number for Information:

1-800-571-7347

Fairfield, CA 94534

Date Prepared

11-14-2007

 

 

Signature of Prepare (Optional)

REGULATORY DEPT.

Section II - Ingredients / Identity Information

Components

(Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits

Recommended.

%(Wt.)

White Mineral Oil

8042-47-5

5mg/m3*

5mg/m3*

 

20-40

Liquefied Petroleum Gas

68476-86-8

1000 ppm

1000 ppm

 

5-10

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This product is not known to contain any compounds listed and in quantities requiring reporting under SARA Title III

Section 313

 

* exposure limits for mist

 

 

Section III - Physical Chemical Characteristics

Boiling Point

 

200°F

Specific Gravity (H2O = 1) @ 70°F

Concentrate

0.949

Vapor Pressure (can; psig @72°F)

 

46 psig

Melting Point

 

N/A

Vapor Density (Air=1)

 

>1

Evaporation Rate (Butyl Acetate = 1)

 

N/A

Solubility in Water

 

Emulsion

pH

 

N/D

Appearance and Odor—

White, oily liquid with little or no odor.

Total VOC%

 

10.04%

Section IV – Fire and Explosion Hazard Data

Flash Point (Conc.)

Flammability (as per CSMA Flame Projection Test)

LEL

UEL

None to Boiling (194°F – T.O)

Non-Flammable Spray

N/A

N/A

Extinguishing Media – Foam, CO2, dry media.

Special Fire Fighting Procedures – Wear self-contained breathing apparatus and protective clothing.  Cool fire exposed containers to prevent rupturing.

Unusual Fire and Explosion Hazards – Exposure to temperatures above 120°F may cause bursting.

 

Page 2 of 2 for    A1017 Always Shine WB

Section V – Reactivity Data

Stability

 

Unstable

Conditions to Avoid –

N/A

Hazardous

Polymerization

May Occur

Stable

X

Will Not Occur

X

Incompatibility (Materials to Avoid) – Avoid contact with strong oxidizing agents.

Hazardous Decomposition or Byproducts – Carbon dioxide, carbon monoxide.

Section VI – Health Hazard Data

Route(s) of Entry:

 

Eyes? 

N/A

Inhalation?

N/A

Skin?

N/a

Ingestion?

N/A

Health Hazards (Acute and Chronic) –

See “Signs and Symptoms of Exposure”

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

No

No

No

Signs and Symptoms of Exposure:

Eyes— May cause slight irritation but does not injure eye tissue.

Skin— Frequent or prolonged contact may cause irritation.

Inhalation— Inhalation of mist can cause irritation of nasal and respiratory passages.  Abusive or excessive inhalation may cause irritation to the upper respiratory tract, dizziness, nausea and other central nervous system effects.

Ingestion—Can cause gastrointestinal irritation, nausea, vomiting and diarrhea.  Aspiration of material into the lungs can cause chemical pneumonitis.

Medical Conditions Generally Aggravated – N/A

Emergency and First Aid Procedures. 

Eyes— Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open.  If irritation persists get medical attention immediately.

Skin—Wash with soap and water.  If irritation persists seek medical attention.

Inhalation— Remove to fresh air.  Seek medical attention immediately.  If breathing stops give artificial respiration.

Ingestion— Do not induce vomiting.  Seek medical attention immediately.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled.

Allow propellant to evaporate.  Maintain local exhaust and adequate ventilation.  No smoking.  Keep sparks, heat sources and open flame far away from spill or leak.  Cover with absorbent material and sweep up.  Wash area to prevent slipping.  Dispose of soaked absorbent material in accordance with Federal, State and local laws.

Waste Disposal Method – Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled.  Consult Federal, State and local authorities for approved procedures.

Precautions to be Taken in Handling and Storing –

Store in a cool, dry area away from heat or open flame.  Do not store at temperatures above 120°F.

Other Precautions – KEEP OUT OF REACH OF CHILDREN.

Section VIII – Control Measures

Respiratory Protection (Specify Type) –

None needed for proper use in accordance with label directions.

Ventilation

Provide local exhaust to keep TLV of Section II ingredients below acceptable limits.

Protective Gloves –None needed for proper use in accordance with label directions.  Use chemical resistant gloves if hand contact will be made.

Eye Protection – None needed unless it is anticipated that a splash or spray back will occur, then wear safety glasses or chemical proof goggles.

Other protective Clothing or Equipment –N/A

Work/Hygienic Practices – Observe good hygiene.  Wash hands thoroughly after product use, eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.