Material Safety Data Sheet May be used to Comply with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. Standard must be Consulted for specific requirements

HMIS

HEALTH 2 REACTIVITY 1

FLAMMABILITY 2 PERSONAL PROTECTION C

Identity (As Used On Label and List) B4122 Glue It

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for: OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number: 1-800-424-9300

Address (Number, Street, City, State, and Zip Code) 101 Grobric Ct #1

Telephone Number for Information: 1-800-571-7347

Fairfield, CA 94534

Date prepared 01-02-2007

Signature of Prepare (Optional) REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components (Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Exposure Limits.

%(Opt.)

Ethyl Cyanoacrylate Ester

Proprietary

None

None

0.2 ppm Twa

Hydroquinone

123-31-9

2mg/m^3 TWA

2mg/m^3 TWA

2mg/m^3 TWA

4mg/m^3 STEL

This product is not known to contain any compounds listed and in quantities requiring reporting under SARA Title III Section 313.

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

Section III - Physical Chemical Characteristics

Boiling Point

<300ºF

Specific Gravity (H2O = 1) Concentrate

1.1

Vapor Pressure (mm/Hg)

Melting Point

Vapor Density (Air=1)

Evaporation Rate (Butyl Acetate=1)

Solubility in Water

Polymerized by H2O

pH

Appearance and Odor— Clear colored liquid, negligible odor.

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

Tag Closed Cup

160-200ºF

N/A

N/A

Extinguishing Media – Carbon dioxide, foam, dry chemical.

Special Fire Fighting Procedures – N/A

Unusual Fire and Explosion Hazards – N/A

Page 2 of 2 for B4122 Glue It

Section V – Reactivity Data

Stability

Unstable

Conditions to Avoid – N/A

Hazardous Polymerization

May Occur

Stable

x

Will Not Occur

x

Incompatibility (Materials to Avoid) – Polymerized by contacts water, alcohols, amines or alkalis.

Hazardous Decomposition or Byproducts – None

Section VI – Health Hazard Data

Route(s) of Entry:

Eyes? Yes

Inhalation? Yes

Skin? Yes

Ingestion? Yes

Health Hazards (Acute and Chronic) – See Below

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

No

No

no

Signs and Symptoms of Exposure: Eyes—May cause irritation. Skin— May cause burns on contact, bonds skin rapidly and strongly. Irritant. Inhalation— N/A Ingestion— N/A

Medical Conditions Generally Aggravated –None Known

Emergency and First Aid Procedures: Eyes—Flush with water Skin—Soak in warm water. Inhalation—Remove to fresh air. If symptoms persist, seek medical attention. Ingestion—Ingestion is not likely.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled– Flood with water to polymerize. Soak up with an inert absorbent.

Waste Disposal Method – Dispose of residue in accordance with federal, state and local regulations.

Precautions to be Taken in Handling and Storing – Store below 75ºF. Avoid breathing vapor.

Other Precautions – KEEP OUT OF REACH OF CHILDREN.

Section VIII – Control Measures

Respiratory Protection (Specify Type) –

Ventilation

Local Exhaust

Special

Mechanical (General)

Adequate

Other

Protective Gloves – Nitrile or polyethylene

Eye Protection – Safety goggles

Other protective Clothing or Equipment – Apron

Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.