Material Safety Data Sheet

May be used to Comply with OSHA’s

Hazard Communication Standard,

29 CFR 1910.1200. Standard must be

Consulted for specific requirements

HMIS

HEALTH 2 REACTIVITY 1

FLAMMABILITY 0 PERSONAL PROTECTION B

Identity (As Used On Label and List)

A1015 Enviro Tac

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for:

OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number:

1-800-424-9300

Address (Number, Street, City, State, and Zip Code)

101 Grobric Ct #1

Telephone Number for Information:

1-800-571-7347

Fairfield, CA 94534

Date prepared

03-09-2005

Signature of Prepare (Optional)

REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components

(Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits

Recommended.

%(Wt.)

3,3-Dicholoro-

1,1,1,2,2- pentafluoropropene *

422-56-0

N/E

20-40

1,3-Dicholoro-

1,1,1,2,2,3- pentafluoropropene *

507-55-1

N/E

20-40

1,1,1,2- Tetrafluoroethane

811-97-2

N/E

20-40

* This substance is a chemical subject to the reporting requirements of Section 313 of title III of the superfund amendments and

reauthorization act of 1986 (SARA) and 40 CFR part 372.

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

Section III - Physical Chemical Characteristics

Boiling Point

~129ºF

Liquid Density (H₂O = 1) @ 77ºF

Concentrate

1.55

Vapor Pressure of can (psig @ 70ºF)

Total VOC

~0%

Vapor Density (Air=1) @ 77ºF

7.0

Evaporation Rate (Butyl Acetate = 1)

Solubility in Water (Wt. % @ 25ºC)

0.033

N/A

Appearance and Odor— Clear, colorless liquid, faint ether-like odor

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

Non Flammable Spray

None to boiling (concentrate only)

N/A

Extinguishing Media – Foam, CO₂, dry media.

Special Fire Fighting Procedures –Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.

Unusual Fire and Explosion Hazards – Exposure to temperature above 120ºF may cause bursting.

Page 2 of 2 for A1015 Enviro Tac

Section V – Reactivity Data

Stability

Unstable

Conditions to Avoid –

Open flames & exposure to high temperatures.

Stable

Incompatibility (Materials to Avoid) – Incompatible with alkali or alkaline earth metals-powered Al, Zn, Be, etc.

Hazardous Decomposition or Byproducts –Hydrofluoric acid and possibly carbonyl fluoride.

Hazardous

Polymerization

May Occur

Conditions to Avoid –

None Listed

Will Not Occur

Section VI – Health Hazard Data

Route(s) of Entry:

Eyes?

Yes

Inhalation?

Yes

Skin?

Yes

Ingestion?

Yes

Health Hazards (Acute and Chronic) –

See Below

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

No

Signs and symptoms of Exposure:

Eyes—Frostbite like effects may occur if the liquid or escaping vapors contact the eyes.

Skin—Immediate effects of overexposure may include : Frostbite if liquid or vapor contact is made with the skin.

Inhalation—Inhalation of high concentrations of vapor is harmful & may cause heart irregularities, unconsciousness, or death. Intentional misuse or deliberate inhalation may cause death without warning. Vapors are heavier than air and may accumulate in low lying or confined areas.

Ingestion— Ingestion is not considered a potential route o exposure.

Medical Conditions Generally Aggravated –None Known

Emergency and First Aid Procedures.

Eyes— Immediately flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention immediately.

Skin—See “Eyes”. Remove contaminated clothing and shoes. Call a physician. Treat for frostbite if necessary by gently warming affected area. Wash contaminated clothing before reuse.

Inhalation—Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration.

Ingestion— Ingestion is not considered a potential route of exposure.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled.

Store in a cool, dry area away from heat or open flame. Do not store at temperatures above 120ºF.

Waste Disposal Method – Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult Federal, State and local authorities for approved procedure.

Precautions to be Taken in Handling and Storing –

Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks, heat sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in accordance with Federal state and local law.

Other Precautions –Keep out of reach of children.

Section VIII – Control Measures

Respiratory Protection (Specify Type) –

None needed for proper use in accordance with label directions.

Ventilation

Local Exhaust

Adequate

Special

Mechanical (General)

Other

Protective Gloves –

None needed for proper use in accordance with label directions. Use chemical resistant gloves if hand contact will be made.

Eye Protection –

None needed unless it is anticipated that a splash or spray back will occur, then wear safety glasses or chemical proof goggles.

Other protective Clothing or Equipment – None

Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.