Material Safety Data Sheet May be used to Comply with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. Standard must be Consulted for specific requirements

HMIS

HEALTH 1 REACTIVITY 3

FLAMMABILITY 4 PERSONAL PROTECTION G

Identity (As Used On Label and List) A1126B Coat It BLACK

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for: OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number: 1-800-424-9300

Address (Number, Street, City, State, and Zip Code) 101 Grobric Ct #1

Telephone Number for Information: 1-800-571-7347

Fairfield, CA 94534

Date Prepared 05-14-2004

Signature of Prepare (Optional) REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components (Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits Recommended.

%(Wt.)

Acetone

67-64-1

1000 ppm

500 ppm

20-30

Propane

74-98-6

1000 ppm

2500 ppm

10-20

n-Butane

106-97-8

800 ppm

800 ppm

01-10

Barium Sulphate, natural

7727-43-7

5mg/m^3

10mg/m^3

01-10

Glycol Ether EP

2807-30-9

25 ppm

25 ppm

01-10

Methyl Isobutyl Ketone*

108-10-1

100 ppm

50 ppm

01-10

Methyl Propyl Ketone

107-87-9

200 ppm

200 ppm

01-10

Xylene (mix)*

1330-20-7

100 ppm

100 ppm

01-10

PM Acetate*

108-65-6

250 ppm

275 ppm

01-10

Isobutyl Acetate

110-19-0

150 ppm

150 ppm

01-10

This product (*) is required to the reporting under SARA Title III Section 313.

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

Section III - Physical Chemical Characteristics

Boiling Point

-47ºF

Specific Gravity (H2O = 1) @ 75ºF Concentrate

0.77-0.90

Vapor Pressure @ 68ºF

8300.0 hPa (6226 (mm/hg))

VOC % by weight

46%

Vapor Density (Air=1)

>1

VOC Content

0.46kg/l

Solubility in Water

Negligible

pH

N/A

Appearance and Odor— Black coating with solvent odor

Solids content

31%

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

Extremely Flammable spray

-2ºF

N/A

N/A

Extinguishing Media – CO2, sand, water spray or dry media.

Special Fire Fighting Procedures –Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.

Unusual Fire and Explosion Hazards – Exposure to temperature above 120ºF may cause bursting.

Page 2 of 2 for A1126B Coat It BLACK

Section V – Reactivity Data
Stability	Unstable				Conditions to Avoid – None
	Stable			X
Incompatibility (Materials to Avoid) – Strong oxidizing agents.
Hazardous Decomposition or Byproducts – Carbon monoxide, carbon dioxide.
Hazardous Polymerization	May Occur				Conditions to Avoid – None
	Will Not Occur			X
Section VI – Health Hazard Data
Route(s) of Entry:	Eyes? Yes				Inhalation? Yes			Skin? Yes			Ingestion? Yes
Health Hazards (Acute and Chronic) – See Below
Carcinogenicity:			NTP?			IARC Monographs?				OSHA Regulated?
			No			No				No
Signs and Symptoms of Exposure: Eyes—Irritating effect. Skin—Frequent or prolonged contact may cause irritation. Inhalation—Inhalation of mist can cause irritation of nasal and respiratory passages. Abusive or excessive inhalation may cause irritation to the upper respiratory tract, dizziness, nausea and other central nervous system effects. Ingestion— Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause chemical pneumonitis. Minimal toxicity.
Medical Conditions Generally Aggravated –None Known
Emergency and First Aid Procedures. Eyes—Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention immediately. Skin—Wash with soap and water. If irritation persists seek medical attention. Inhalation—Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration. Ingestion—Do not induce vomiting. Seek medical attention immediately.
Section VII – Precautions For Safe Handling and Use
Steps to be Taken in Case Material is Released or Spilled. Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks, heat sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in accordance with Federal state and local law.
Waste Disposal Method – Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult Federal State and local authorities for approved procedures.
Precautions to be Taken in Handling and Storing – Store in a cool, dry area away from heat or open flame. Do not store at temperatures above 120ºF.
Other Precautions –Keep out of reach of children.
Section VIII – Control Measures
Respiratory Protection (Specify Type) – If ventilation not adequate to reduce vapors below Threshold limit Value (TLV) levels, use a NIOSH/MSHA approved air-purifying respirator.
Ventilation		Local Exhaust			Adequate				Special
		Mechanical (General)							Other
Protective Gloves – Use chemical resistant gloves, if hand contact will be made.							Eye Protection – Wear chemical proof goggles.
Other protective Clothing or Equipment – None
Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.