Material Safety
Data Sheet
May be used to Comply with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. Standard must be Consulted for specific requirements |
HMIS |
||||||||||||
HEALTH 3 REACTIVITY 2 |
|||||||||||||
FLAMMABILITY 2 PERSONAL PROTECTION D |
|||||||||||||
|
Identity (As Used On Label
and List) B4114 Liquid Auger |
Note: Blank spaces are not permitted. If any item is not applicable, or no
information is available, the space must be marked to indicate that.
|
||||||||||||
Section I
|
|||||||||||||
|
Manufactured for: OMEGA INDUSTRIAL SUPPLY, INC |
Emergency Telephone Number: 1-800-424-9300 |
||||||||||||
|
Address (Number, Street,
City, State, and Zip Code) |
Telephone Number for
Information: 1-800-571-7347 |
||||||||||||
|
|
Date Prepared
03-16-2006 |
||||||||||||
|
|
Signature of Prepare
(Optional) REGULATORY
DEPT. |
||||||||||||
|
Section II -
Hazardous Ingredients / Identity Information |
|||||||||||||
|
Hazardous
Components (Specific
Chemical Identity, Common Name(s)) |
CAS No. |
OSHA PEL |
ACGIH-TLV |
Other Limits Recommended. |
%(Wt.) |
||||||||
|
Sulfuric Acid* |
7664-93-9 |
1mg/m3 |
1mg/m3 |
|
92 % |
||||||||
|
Orthodichlorobenzene* |
95-50-1 |
N/A |
4000 ppm (TWA) |
|
1.0 % |
||||||||
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
||||||||
|
|
|||||||||||||
|
“*”This product is a chemical subject to the reporting requirements of Section 313 of Title III of the superfund amendments and |
|||||||||||||
|
reauthorization act of 1986 (SARA) and 40CFR Part 372. |
|||||||||||||
|
|
|||||||||||||
|
Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or |
|||||||||||||
|
|
|||||||||||||
|
|
|||||||||||||
Section III -
Physical Chemical Characteristics
|
|||||||||||||
|
Boiling Point |
356ºF (Ortho) |
Specific Gravity (H2O
= 1) Concentrate |
1.8 |
||||||||||
|
Vapor Pressure
(mm/hg) |
N/A |
% Volatile by
Volume |
8 % |
||||||||||
|
Vapor Density (Air=1) |
N/A (Heavier) |
Evaporation Rate
(Butyl Acetate = 1) |
Slower |
||||||||||
|
Solubility in Water |
99% |
pH |
<1 |
||||||||||
|
VOC% |
<2 |
Weight/Gallon (H2O =8.33#) |
15# |
||||||||||
|
Appearance and Odor—Two phase system. Lower layer black-red. Upper-Clear to black. Solvent odor |
|||||||||||||
Section IV –
Fire and Explosion Hazard Data
|
|||||||||||||
|
|
Flammable Limits |
LEL |
UEL |
||||||||||
|
|
155ºF |
2.2 |
9.2 |
||||||||||
Extinguishing Media – Foam, water fog, gas (CO2/halon), dry chemical.
|
|||||||||||||
|
Special Fire Fighting Procedures –Do not spray water directly on drain
cleaner. Acid reacts violently with
water and can cause spattering. Wear
protective clothing, eye face, and skin protection and NIOSH approve
self-contained breathing apparatus.. |
|||||||||||||
|
Unusual Fire and Explosion Hazards –
At high temperatures, sulfuric acid mist or sulfur trioxide gas can be
released from vented or ruptured containers. |
|||||||||||||
Page 2 of 2 for B4114 Liquid Auger
Section V –
Reactivity Data
|
||||||||||||
|
Stability |
Unstable |
Conditions to
Avoid – None Listed |
||||||||||
|
X |
||||||||||||
|
Incompatibility (Materials
to Avoid) – Do not mix with other chemicals. Keep away from combustible material |
||||||||||||
|
Hazardous Decomposition or Byproducts –Sulfuric trioxide gas. |
||||||||||||
|
Hazardous Polymerization |
May Occur |
Conditions to
Avoid – Do not add water to
drain opener, always add drain opener to water. Do not store in metal containers or in
extreme heat. |
||||||||||
|
Will Not
Occur |
X |
|||||||||||
Section VI –
Health Hazard Data
|
||||||||||||
Route(s) of
Entry:
|
Eyes? Yes |
Inhalation?
Yes
|
Skin?
Yes
|
Ingestion?
Yes
|
||||||||
|
Health Hazards (Acute and
Chronic) – Acute— Danger: Causes severe burns. Do not get in eyes, on skin, or clothing. Chronic—Prolonged inhalation of
fumes or acid mist can cause irritation and burns of the respiratory tract. |
||||||||||||
Carcinogenicity:
|
NTP?
|
IARC Monographs?
|
OSHA Regulated?
|
|||||||||
|
|
N/A
|
N/A
|
N/A
|
|||||||||
|
Signs and
Symptoms of Exposure: See Above |
||||||||||||
|
Medical Conditions Generally Aggravated –None
Known |
||||||||||||
|
Emergency and
First Aid Procedures. Eyes—Immediately flush with plenty of water for at
least 15 minutes, until medical attention is received. Skin—See “Eyes” Remove clothing if contaminated with
acid. Inhalation—Remove to fresh air. Get medical attention. Give artificial respiration if breathing
has stopped. Ingestion—Drink large quantities of water or milk followed
with milk of magnesia, beaten eggs, or vegetable oil. Get immediate medical attention. |
||||||||||||
Section VII –
Precautions For Safe Handling and Use
|
||||||||||||
|
Steps to be
Taken in Case Material is Released or Spilled. Sprinkle an excess of
sodium bicarbonate or soda ash on spill until foaming ceases and acid is
neutralized. Rinse area with water. |
||||||||||||
|
Waste Disposal Method – Drum off and dispose of
according to local regulations for hazardous waste. |
||||||||||||
|
Precautions
to be Taken in Handling and Storing – Product is a strong acid
and reacts violently with water. Do
not get on skin, eyes, or clothing. If
spilled on clothing, remove clothing quickly and flush off exposed skin with
water. Do not take internally can be
fatal if swallowed. Store in a cool, dry
area away from combustible materials.
Do not transfer to metal containers.
|
||||||||||||
|
Other Precautions –Keep out of reach of
children. |
||||||||||||
Section VIII –
Control Measures
|
||||||||||||
|
Respiratory
Protection (Specify Type) – None Required |
||||||||||||
|
Ventilation |
Local Exhaust |
Adequate |
Special |
|
||||||||
|
Mechanical
(General) |
|
Other |
|
|||||||||
|
Protective
Gloves – Wear acid resistant
gloves |
Eye
Protection – Wear eye glasses or
goggles and full face shield |
|||||||||||
|
Other protective Clothing or Equipment – Wear
apron, and boots. |
||||||||||||
|
Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating,
drinking, and using restrooms, etc. |
||||||||||||
|
||||||||||||
While the information and recommendations set forth
herein are believed to be accurate as of the date hereon Omega Industrial
Supply Inc. makes no warranty with respect thereto and disclaims all liability
from reliance thereon.