Material Safety Data Sheet

May be used to Comply with OSHA’s

Hazard Communication Standard,

29 CFR 1910.1200. Standard must be

Consulted for specific requirements

HMIS

HEALTH 1 REACTIVITY 1

FLAMMABILITY 0 PERSONAL PROTECTION B

Identity (As Used On Label and List)

B4092 Anti Seize Brush Top

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for:

OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number:

1-800-424-9300

Address (Number, Street, City, State, and Zip Code)

101 Grobric Ct #1

Telephone Number for Information:

1-800-571-7347

Fairfield, CA 94534

Date Prepared

02-07-2008

Signature of Prepare (Optional)

REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components

(Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits

Recommended.

%(Wt.)

Copper Compound

7440-50-8

N/E

"*" If present, IARL, NTP and OSHA carcinogens and chemical subject to this reporting requirements of SARA Title III,

Section 313

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

Section III - Physical Chemical Characteristics

Boiling Point

N/A

Specific Gravity (H₂O = 1) @ 75ºF

Concentrate

1.394

Vapor Pressure (mm/hg)@ 75ºF

Nil

Total VOC%

~0%

Vapor Density (Air=1)

Evaporation Rate (Butyl Acetate = 1)

Solubility in Water

Negligible

Appearance and Odor— Gray viscous grease, slight petroleum odor.

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

>380ºF

N/A

Extinguishing Media – Water fog, foam, CO₂, dry media.

Special Fire Fighting Procedures –Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.

Unusual Fire and Explosion Hazards – Dense smoke.

Page 2 of 2 for B4092 Anti Seize Brush Top

Section V – Reactivity Data
Stability	Unstable				Conditions to Avoid – None
	Stable			X
Incompatibility (Materials to Avoid) – Strong oxidizing agents.
Hazardous Decomposition or Byproducts – Carbon monoxide, carbon dioxide.
Hazardous Polymerization	May Occur				Conditions to Avoid – None
	Will Not Occur			X

Section VI – Health Hazard Data
Route(s) of Entry:	Eyes? Yes				Inhalation? Yes		Skin? Yes			Ingestion? Yes
Health Hazards (Acute and Chronic) – See Below
Carcinogenicity:			NTP?			IARC Monographs?			OSHA Regulated?
			No			No			No
Signs and Symptoms of Exposure: Eyes—Causes pain, redness and irritation. Skin— Frequent or prolonged contact may cause irritation. Inhalation—Inhalation is not a likely route of exposure. Ingestion—Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause chemical pneumonitis.
Medical Conditions Generally Aggravated –None Known
Emergency and First Aid Procedures. Eyes— Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention immediately. Skin—Wash with soap and water. If irritation persists seek medical attention. Inhalation—Remove to fresh air. Ingestion—Seek medical attention immediately.
Section VII – Precautions For Safe Handling and Use
Steps to be Taken in Case Material is Released or Spilled. Cover with suitable absorbent material and scoop or sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in accordance with Federal, State and local laws.
Waste Disposal Method – Consult Federal, State and local authorities for approved procedures.
Precautions to be Taken in Handling and Storing – Store in a cool, dry area away from heat or open flame.
Other Precautions –KEEP OUT OF REACH OF CHILDREN.
Section VIII – Control Measures
Respiratory Protection (Specify Type) – None needed for proper use in accordance with label directions.
Ventilation		Local Exhaust			Not normally required			Special
		Mechanical (General)						Other
Protective Gloves – Use chemical resistant gloves if excessive hand contact will be made.						Eye Protection – As when working with any chemical, wear safety glasses.
Other protective Clothing or Equipment – N/A
Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.